New Rowan Oak print

I haven’t been sketching this week, and I’m missing it, but I’ve been getting some good work done on a new print for my Rowan Oak show next year. This is an especially complex piece. I had a lot of colors I wanted to include, and I hate to carve and print more than three blocks per print. So laying it out got complex, and I’m mixing more than one color for each block, but I loved the sketch I did of this tree, and it’s worth the aggro. I’m doing a series of color proofs as I keep refining the carving as well. At top is the best one so far. The key block is usually all black for my prints, but that was too harsh in this case, so for the top layer I’ve added a brown tree trunk for the cedar and softened to more gray around the edges. You can see the all black version at the bottom of the three proofs together just below. On the middle one I went too grey away from the tree and lost definition on the building. this one I think is the closest to what I want, but I need to clean up some carving, especially in the tree and the building. I’ve also added a snapshot of the three blocks together. The orange green goes first, then the grey of the building, tree, and grass along with the green of the cedar. Finally the black of the tree, the cedar trunk, and the definition of the building go on top.

Here is the original sketch with the first layer of the print.